Publicité
Les langues disponibles
Les langues disponibles
Remote Control
This machine can be remotely controlled using the buttons of an ordinary tone dialling
telephone. Call up the answer machine and enter the
page
4) while the outgoing message is playing. Once the code is accepted, several remote
control commands are available.
1.
Call up the answer machine (the number that your device is connected to, usually your
home number).
2 .
While the outgoing message is playing, enter the
will hear two beeps.
3 .
Select a remote control command (within 10 seconds) from below.
4 .
When you have finished accessing the machine, replace the handset.
Command
1#
2#
During playback:
3#
4#
5#
6#
After playback:
7#
8#
9#
0#
Please note!
If the machine doesn't respond correctly to the remote control commands, try pressing the
telephone buttons for a longer or shorter time. In normal cases, the answer machine should
react to tones approximately 0.5 – 1 seconds in length, but longer tones may be necessary
in certain telephone networks.
If you do not enter any remote control command, the answer machine will disconnect after
a few seconds.
If you listen to any incoming messages for more than 2 minutes and 40 seconds, you will
hear two beeps. Press any button to continue.
All manuals and user guides at all-guides.com
English
Function
Play new messages
Play all messages
Erase single message during playback
Skip to previous message
Stop playback
Skip to next message
Turn the answer machine either On or Off.
Record a new outgoing message, to Stop recording press
Record a MEMO, to Stop recording press
Room monitoring (active for 2 minutes and 30 seconds,
�r���
to continue).
0#
PIN CODE
(please refer to
PIN CODE
. If the code is accepted, you
5#
15
5#
.
.
Publicité
