RISCO Group Industrial LuNAR DT AM Grade 3 Guide D'installation page 30

All manuals and user guides at all-guides.com
When using the Remote Control device, it is recommended to perform the LuNAR Self Test; for further
instructions refer to the Remote Control Instructions.
Upon completion of installation and testing stages, ensure that all switches are in their desired positions.
IMPORTANT:
Turn DIP switch 7 "OFF" after installation and when leaving
the site for security reasons. This will prevent unauthorized
use of a remote control unit, that may be used to disable the
detector.
Troubleshooting
This section describes possible system problems and their solutions:
Always perform the following preliminary checks before referring to the troubleshooting table:
Ind. LuNAR RK200DTG3 Installation Guide 29