Télécharger Imprimer la page

RISCO Group Industrial LuNAR DT AM Grade 3 Guide D'installation page 29

Masquer les pouces Voir aussi pour Industrial LuNAR DT AM Grade 3:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 100
All manuals and user guides at all-guides.com
Walk Test
NOTE:
To perform the walk test, first enable the LEDs.
Two minutes after applying power (warm-up period), walk test the detector over the entire protected area
to verify proper operation of the detector and observe the Tri - color LED. The edge of the microwave
pattern is determined by the first red LED activation (both PIR and MW LEDs are triggered).
NOTE:
If the PIR/MW LEDs do not TURN ON, probably it means that there
is a problem with either the lens (PIR) position, or MW adjustment!
Adjust the microwave sensitivity by turning the PCB potentiometer (using a screwdriver), or by using the
Remote Control device. Walk test the unit from all directions to determine all the detection pattern
boundaries.
NOTE:
Adjust the MW to the lowest possible setting that will still
provide enough coverage for the entire protected area!
28
Ind. LuNAR RK200DTG3 Installation Guide

Publicité

loading

Ce manuel est également adapté pour:

Rkk200dtg3