Publicité
Les langues disponibles
Les langues disponibles
3.2. Main components
9
2
...
4
8
10
3
Image A
Heater
1
Handle
2
3
Power cable
Display
4
Wing nuts (4 pieces)
5
3.3. Assemble the appliance
1
ATTENTION
Risk of damage to the appliance:
• Make sure you have fully assembled the appliance before you start using it.
1. Place the heater upside down on a flat, stable, soft surface.
2. Slide the U-bracket through the space between the rear two bars of the heater.
3. Place the foot with the castors over the ends of the U-bracket.
4. Tighten the foot by tightening the two wing nuts over the ends of the U-bracket.
5. Place the other foot over the two threaded ends of the housing of the front of the heater.
6. TTighten the foot by tightening the two wing nuts over the threaded ends.
7. Turn the heater over so that it is on the castors.
8. Insert the batteries (two pieces, AAA, 1.5V, not included) into the remote control battery compartment.
USER MANUAL
1
6
7
8
9
10
4×
5
1×
6
2×
7
U-bracket
Foot with castors (2 pieces)
Cable storage brackets
Remote control
Remote control battery compartment
23
Publicité
