CUISIMAT 3237580 Manuel D'instructions page 96

For regular and constant service of the unit it would be well to regularly carry out general cleaning and
maintenance operations.
WARNING: The cleaning and mantainance of the refrigerating engine and the compressor area needs the
intervention of a skilled technician, therefore it cannot be done by other persons.
Clean the exterior and interior surfaces with soap or a neutral detergent and water: a little vinegar added to
the water will eliminate any eventual foul odours.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the two upper screws
2. Unhook the dashboard pushing it in a downward direction
WARNING: to assure a regular use of the machine it is necessari to clean the copper-alluminium
condensator at least every 30 days.
Accurately clean the condenser in the refrigerating unit and the inner evaporator with either a vacuum
cleaner, a bristle brush or a non-wire brush after removing the protections.
The cleaning and mantainance operations have now come to end.
USEFULL ADVICES FOR THE CARE OF THE STAINLESS STEEL
For the cleaning and mantainance of the parts of stainless steel follow the advices written below, bearing in
mind that the first and fundamental rule is to guarantee the non toxicity and best hygiene of the dealed
products.
The stainless steel has a thin oxide coat that prevents rust formation.
But there are substances or detergents that can destroy this coat and give origin to corrosions.
Before using any detergent product ask always your dealer about which neutral detergent is the most
qualified and does not cause corrosions on the steel.
In case of scratches on the surfaces it is necessary to smooth them using thin STAINLESS STEEL wool or
an abrasive sponge in synthetic fibrous material, wiping in the direction of the satin
WARNING: for the cleaning of the STAINLESS STEEL never use iron wool and never let them rest on the
surfaces because little iron deposits could remain on the surfaces and cause rust formations by
contamination and endanger the hygiene.
GENERAL CLEANING AND MAINTENANCE
20