CUISIMAT 3237580 Manuel D'instructions page 87

Push the on/sby/enter to confirm the choice and activate the function.
After 30 seconds if not confirmed the program exits the function.
To unblock the keyboard push the buttons simultaneously and hold
down for more than 5 seconds: to confirm this operation the [UnL] will flash
on the display.
When the keyboard is blocked the label [Loc] will appear on the display when
any key is pressed.
PROBE READING MANUAL PRINTING:
Coupled with the TSP print terminal
( only on -25° C / -15° C and -20° C / + 5° C units)
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Utilise the up button to visualise the [Prt] function.
Push the on/sby/enter to confirm the choice and activate the function.
After 30 seconds, if not confirmed, the program exits the function.
PARAMETER CONFIGUTATION
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Use the up and down keys to display the function [PAr].
Press the on/sby/enter key to enter the parameter configuration mode.
After 30 seconds if not confirmed the program exits the function.
Enter the password to gain access.
The display shows the password setting mode [00]
Use the up and down keys to select the password "65"
Press the on/sby/enter key to confirm your selection.
If the password is correct, the display shows the first parameter in the
configuration list.
Use the up and down keys to scroll the controller parameters
Press the on/sby/enter key to confirm your selection.
Use the keys up and down to select the new value
11