Publicité
Appendix
A. Troubleshooting
Status LEDs
Condition
Loading system after power on
During booting procedure
Detecting and setting network
After network is setup (system up)
During the upgrade firmware process
Resetting and restoring
At the back side of the netzwork camera is a button. Press this button to reset the system or restore
the factory parameter settings. Sometimes the normal system status can be restored by a reset. If you
have further problems following a reset, restore the factory parameter settings and reinstall and
reconfigure the system.
RESET:
Press the reset button with a pointed object.
RESTORE:
1. Press the button continuously with a pointed object.
2. Wait until the LEDs blink fast.
3. Release the reset button.
LED color
Steady blue
Steady blue and red
Steady blue and blink red till IP address is
confirmed
Blink blue every second and steady red
Blink blue every second and fast blink red
If the factory parameter settings are restored, all
the previous settings are deleted. The system can be
reset or restored.
Reset-Button
34
Publicité
