Publicité
Les langues disponibles
Les langues disponibles
Cautions when starting the engine
en
3.6 CAUTIONS DURING OPERATION
Handle fuel and lubricating oil safely - No fire
8
REN650DK
Before starting the engine, check the safety around the
machine.
When there is a co-worker, give a signal to him/her to
prepare for the operation.
During the operation, be careful to prevent infants or
livestock from coming near the engine.
When starting with the start handle:
- When starting, fit the start handle´s claw to start shaft´s
pin securely.
- If the start handle´s claw is deformed (worn or missing) or
if its fitting status is not good, do not use the claw but
replace it with a new one.
- Even after the engine has started, hold the start handle
securely and do not release it.
When starting with "self-start":
- Do not start the engine by shorting the starter circuit. This
start method is dangerous and sometimes, damages the
machine.
Before the operation, make sure that there is not a person and obstacles at the front and rear of
the machine.
Be very careful when operating the machine on a slope.
On a hard ground (concrete or frozen ground), do not operate the machine with vibration.
Fuel is inflammable and dangerous. Lubricating oil is also
inflammable and dangerous. Handle them carefully.
- While replenishing the fuel or lubricating oil, stop the
engine.
- Replenish the fuel outdoors under the good ventilated
condition.
- If the spilled fuel or lubricating oil can catch fire at the hot
part, wait until the engine is cooled and then replenish the
oil.
- Always wipe away the spilled fuel and lubricating oil.
- To prevent a fire, always wipe away the stain accumulated
on the engine, oily substances and dust.
- Store the inflammable fuel and other oils far away from
fire.
DUPLEX VIBRATING ROLLER
Publicité
