Audiovox PRESTIGE PLATINUM APS 600 Manuel D'installation page 4

2 Dark Green w/ White Trace Wires : ENTRY ILLUMINATION
The dark green w/ white trace wires provide the entry lighting, and flash the vehicle's dome light while the
alarm is sounding. These are NO ( normally open ) and COM ( common ) contacts of an on board, 10
Amp maximum relay.
Connect one of the dark green w/ white trace wires to the wire in the vehicle that turns on the interior
courtesy light. Connect the other dark green w/ white trace wire to either chassis ground if the vehicle
switches ground to the courtesy lights, or a fused + 12 volt constant battery source if the vehicle
switches 12 volts to the courtesy lights.
NOTE : When wiring this feature in vehicles with factory equipped delay lighting circuits, it is
White w/ Black Trace Wire : POSITIVE OUTPUT TO SIREN
Route this wire through a rubber grommet in the firewall, and to the siren location.
Connect the white / black wire to the positive wire of the siren. Secure the black ground wire of the siren
to chassis ground.
Mini 10 Pin Edge Connector :
Light Green Wire : ( - ) INSTANT TRIGGER ZONE 1
This is an instant on ground trigger wire. This wire ( zone ) should be reserved for connection to optional
ground output trigger devices such as motion and / or shock impact sensors.
White w/ Blue Trace Wire : HEADLIGHT OUTPUT - ARM & DISARM
The white w/ blue trace wire is provided to control the optional headlight illumination feature of the
system. This is a transistorized, low current ( 300 mA ) output, and should only be used to drive an
external relay coil.
This wire provides a 30 second ground signal whenever the system is remotely armed or disarmed..
Connect the white w/ blue trace wire to terminal 86 of the AS 9256 relay ( or an equivalent 30 Amp
automotive relay ), and connect relay terminal 85 to a fused + 12 VDC battery source. Connect relay
terminal 87 to one of the low beam headlight wires in the vehicle, and connect relay terminal 30 to
either chassis ground or a fused ( 15 Amp Min ) + 12 VDC battery source, depending on the polarity of
the headlight circuit in the vehicle.
Yellow Wire : + 12 VDC IGNITION SOURCE
Connect this wire to a source that is live when the key is in the on and crank positions. Be sure that this
source is off when the key is in the off position.
Purple Wire : + DOOR TRIGGER
If the vehicle's door courtesy light switches have a + 12 volt output when the door is opened ( most
Fords and some Imports ), you must connect this wire to the positive output from one of the door
switches. In most cases, the purple wire will only need to be connected to one door switch, no matter
how many doors the vehicle has.
WARNING : Do not use the purple wire if the vehicle has ground output type door switches. ( see Brown
Brown Wire : - DOOR TRIGGER
If the vehicle's courtesy light switches have a ( - ) ground output when the door is opened ( GM and
most Imports ), you must connect this wire to the negative output from one of the door switches.
WARNING : Do not use the brown wire if the vehicle has + 12 volt output type door switches. ( see
Get user manuals: See SafeManuals.com
best to connect to the output of the timer which feeds the dome light, rather than at the
door switch. This will ensure that the dome light pulses when the alarm is triggered.
Wire ).
Purple Wire ).
Page 4