Publicité
3. Safety Information
Hose
•
This appliance may only be used outdoors.
•
A hose and regulator is supplied with this appliance (South Africa Only)
•
The hose must be checked for wear or damage before every use and before
connecting to the gas container.
•
Do not use the appliance if it has a damaged or worn hose. Replace the hose.
•
Do not use the appliance if it is leaking, damaged or which does not operate properly.
Gas Container
•
Only use a cylinder that is approved by your countries regulations.
•
Ensure that the gas container is fitted or changed in a well-ventilated location,
preferably outdoors, away from any sources of ignition such as naked flames, pilots,
electric fires and away from other people.
•
Keep gas containers away from heat and flame. Do not place on a stove or any other
hot surface.
•
Gas cartridges/refillable cylinders are to be used only in the upright position so as to
ensure proper fuel withdrawal. Failure to adhere to this may cause liquid discharge
from the gas container resulting in a dangerous operating condition.
•
Do not try to remove the cylinder whilst the unit is in operation.
•
A space has been provided in the centre of the utility tray to place a gas cartridge
into.
•
The gas cylinder must be disconnected from the appliance after use or when in
storage.
Assembly and use
•
The appliance is designed to be portable, therefore the legs and the utility tray is
easily removable / assembled the ease of transport and use.
•
User assembly / dis-assembly is limited to the fitment of the legs, utility tray, and
the installation / removal of cooking surfaces.
•
When assembling the legs, always make sure that the leg securing rings have been
securely fastened and that the assembled product is stable and does not rock.
Do not use the appliance without fitting the Accessories Tray as it also plays an
important role in ensuring the overall sturdiness of the appliance.
•
Use only on a firm level surface.
•
Do not move the appliance whilst the unit is in operation.
•
Should the Heat Shield, Fat Pan or Burner Pan become damaged in such a way
that permanent contact between the Heat Shield and the Fat Pan occurs during
use, do not use the appliance. Return it to your Cadac stockist for repair.
•
Do not cover up or change the Air Holes in the Valve Box Cover as this will affect
the performance of the product
and may lead to an unstable flame.
•
Ensure the appliance is used away from flammable materials. Minimum safe
distances are: Above the appliance 1.2m. At the rear and sides 600mm. (See Fig.
2)
Caution: When using the appliance, we recommend the use of protective gloves
•
when removing and applying the dome, as the dome handle may become hot.
•
Caution: Accessible parts may become very hot, the use of protective gloves is
recommended.
•
Keep young children away from the appliance.
•
Use Outdoors Only
•
NOTE! If the appliance is used in windy conditions, the dome must be used as a
wind shield, and placed in position as shown in Fig. 4.
Light back
•
In the event of light back (where the flame burns back and ignites inside the
burner or venturi housing), immediately turn off the gas supply by firstly closing the
control valve on the gas container and then the appliance valve. After the flame is
extinguished, remove the regulator and check the condition of the seal; replace the
seal if in doubt. Re-light the appliance as described in Section 6 below. Should the
flame persistently light back, return the product to your authorised CADAC repair
agent.
Leaks
•
If there is a leak on your appliance (smell of gas), immediately close the control knob on the gas cylinder. If you wish to check for leaks on your
appliance, do it outside. Do not try to detect leaks using a flame; use soapy water.
•
The correct way is to smear the joints with soapy water. If a bubble or bubbles form then there is a gas leak. Immediately turn off the gas supply
firstly by closing the control valve on the gas container and then the appliance valve. Check that all the connections are properly fitted. Re-check
with soapy water. If a gas leak persists, return the product to your CADAC dealer for inspection / repair.
•
Check for leaks on the tailpiece by the valve and on the cylinder regulator fitting with gas open on cylinder but not open or switched on by the
appliance control knob.
All manuals and user guides at all-guides.com
2 2
Hose
Regulator
Fit hose
clamp
here
Cylinder Valve
Only applicable to
8910-10, 8910-20,
8910-30, 8910-40,
8910-50, 8910-70
& 8910-80
Seal
Fig. 1
Fig. 2
Fig. 3
WIND
Fig . 4
Publicité
