Krups BeerTender Mode D'emploi page 19

Cleaning after daily use
All manuals and user guides at all-guides.com
The drip tray and grate should be cleaned after every use.
Remove the grate before emptying out the drip tray. The
grate must be set back in place during normal use of the
BeerTender.
Note: You can wash the drip tray with warm water and a
mild detergent. The drip tray is also dishwasher safe.
Warning! Never use aggressive cleaning agents such as
vinegar, acids, solvents or petrol.
Cleaning after installation of a new BeerTender Keg
When you install a new BeerTender Keg you must clean
the dispensing spout. The spout is the only part of the
appliance that comes into contact with the beer.
It is essential to wash the spout either normally by hand
or in a dishwasher.
Note: the dispensing spout comprises plastic and metal
parts that are permanently joined together and do not
pose any problems of hygiene. Do not attempt to
separate these parts.
The beer dispensing mechanism must be cleaned using
a damp cloth and a mild detergent.
Note: use a piece of cotton to thoroughly clean all the parts.
Warning! Do not attempt to clean the mechanism using
hard and/or sharp objects: it is a precision component
and you will risk damaging it.
Routine cleaning
Clean the appliance cooling chamber on a regular basis
using a damp cloth and mild detergent.
Warning! Do not fill the cooling chamber with water as
this may result in permanent damage. Never use
aggressive agents such as vinegar, acids, solvents or
petrol.
18