Eneo DLR5-08 Guide D'installation Rapide page 35

To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, the front panel LEDs will blink. When the front pan-
el LEDs blink, poke the straightened paperclip into the unlabeled hole to the left
of the HDMI connector.
4. Hold the switch until the DVR's internal buzzer sounds twice.
5. Release the reset switch. All of the DVR's settings are now at the original set-
tings it had when it left the factory.
Video Out
both the HDMI and VGA OUT Monitor connectors, one of the monitors should be
connected before the DVR boots, and the other monitor should be connected after
the DVR boots.
An HDMI (High-Definition Multimedia Interface) connector is provided so that you
can use an HDMI monitor as your main monitor.
A VGA connector is provided so that you can use a standard, multi-sync computer
monitor as your main monitor. Use the cable supplied with your monitor to connect
it to the DVR.
Connect the spot monitor to the SPOT connector as needed.
Network Port
The DVR can be networked using the 10/100Mb Ethernet connector.
Connect a Cat5 cable with an RJ-45 jack to the DVR connector. The
DVR can be networked with a computer for remote monitoring, search-
ing, configuration and software upgrades.
All manuals and user guides at all-guides.com
NOTE: Connect the monitor before
the DVR boots so that video can
be displayed on the monitor with
the resolution you have set during
system setup. If you want to use
DE
EN
FR
PL
RU
35