Quality Espresso Q MILK Mode D'emploi page 22

4.
Cleaning and maintenance
WARNING!
It is very important that the milk container and tap be cleaned daily:
a-, Ensure that the warmer's electric cable is disconnected from the mains.
b-, Empty the remaining milk via the tap.
c-, Pour water and a little biodegradable detergent into the milk container, so that the particles of milk attached to the si-
des of the container are released.
d-, Empty and fill the container a few times with clean water, until the container is cleand and free from
e-, Remove the tap and clean as indicated (Fig. 7 & 8).
Unscrew the grooved nut of the tap (Figure 7) so as to remove the lever and axis for cleaning. Clean the interior of the
outlet tube using the spiral brush enclosed (Fig 8).
Reassemble the tap.
Figure 7
- Refill the tank with the water to the water level mark and reinsert the milk container as explained in 3.3 "Using the war-
mer".
- The case and tanks are made from stainless steel plate. To clean, use non-abrasive products to avoid scratching.
5.
Troubleshooting
PROBLEM
Milk does not heat (ON/OFF and resistor
lights off).
The milk does not heat (ON/OFF switch light
on, resistor light always off).
The milk does not heat (ON/OFF switch light
and resistor light on).
Water level light flashes.
The tap drips while closed.
POSIBLE CAUSE
Check that the electricity supply has not
been switched off.
Check that the electrical data shown on the
plate match the ones of the mains supply.
Thermostat is not functioning.
Resistor is defective.
Water level in the water tank has lowed
leaving the probe undercovered.
Internal closing gasket faulty.
22
detergent.
Figure 8
SOLUTIONS
Disconnect the warmer from the mains and
check the electric cabling, the mains connec-
tion plug and the ON/OFF switch.
Change the thermostat.
Change the resistor.
Refill the water in the water tank.
Change the gasket.