Electrical
connection
•
Manipulation
•
•
•
•
•
Note: this warmer does not surpass 70 dB of acoustic pressure.
Check that all of the electrical connection characteristics comply with
the voltage, frequency and wattage indications described on the war-
mer's specification plate.
We consider the warmer to be installed correctly when it has been
connected to a magneto-thermic omnipolar circuit breaker appropriate
to the Dispenser's power, along with a differential that does not ex-
ceed a residual current of 30 mA.
The warmer must be installed in accordance with the current electrical
regulations of your area. You must make sure that the electrical insta-
llation is reliably grounded in accordance with the aforementioned re-
gulations. The company declines any liability for possible injuries cau-
sed by a defective installation or incorrect ground connenction.
Extension cables or outlet adapters of any kind should not be used to
connect the warmer to the power supply. The connection cables
should never be rolled up, but instead they should be fully extended to
avoid possible overheating.
Any internal manipulation of the warmer, except that which is speci-
fically described in this manual regarding cleaning processes, must
be performed by an authorized service technician.
Cleaning and preventive maintenance according for the warmer or
by the service technician is required.
The manufacturer declines any responsibility for the possible dama-
ge to the warmer due to non-compliance with these requirements,
as well as damage due to the incorrect or inappropriate use of the
warmer.
All warmer components, including the electrical connection cable,
should only be replaced by original parts. If the electrical connection
cable is damaged, it should be replaced by the manufacturer, a ser-
vice technician, or by similarly qualified personnel so as to avoid any
danger.
Before proceeding with any maintenance operations, disconnect the
dispenser from the electrical supply either through the mains gene-
ral switch or by disconnecting the power cable.
This Warmer only will be used for milk heat and not other products.
16