Hilti C 7 Mode D'emploi page 13

All manuals and user guides at all-guides.com
For indoor use only
Double insulated
1.4 Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Charger
Generation
Serial no.
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916 Kaufering, Germany
2 Safety
2.1 General safety instructions
WARNING Read all safety instructions and other instructions. Failure to observe the safety instructions
and other instructions may result in electric shock, fire and/or serious injury.
Keep all safety precautions and instructions for future reference.
The term "electric tool" used in the safety instructions refers to your mains-operated (corded) electric tool or
battery-operated (cordless) electric tool.
Working area safety
▶ Keep your working area clean and well lit. Cluttered or dark working areas can cause accidents.
▶ Do not operate the power tool in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
▶ Keep bystanders, children and visitors away while operating the power tool. Distractions may cause
you to lose control of the tool.
Electrical safety
▶ The plug on the supply cord of the power tool must match the power outlet. Do not change the
plug in any way. Do not use adapter plugs with earthed (grounded) power tools. Unmodified plugs
and matching power outlets reduce the risk of electric shock.
▶ Avoid body contact with earthed or grounded surfaces such as pipes, radiators, cookers, stoves
and refrigerators. There is an increased risk of electric shock if your body is grounded.
▶ Do not expose the power tool to rain or wet conditions. Water entering a power tool will increase the
risk of electric shock.
▶ Do not abuse the cord. Never use the cord to carry or hang up the power tool or to pull the plug
out of the power outlet. Keep the cord well away from heat, oil, sharp edges and moving parts.
Damaged or twisted supply cords increase the risk of electric shock.
▶ Use the battery charger only inside dry rooms. Water entering an electric appliance will increase the risk
of electric shock.
2.2 Battery charger use and care
▶ To avoid injury, use the charger only to charge Hilti Li-ion batteries approved for use with this charger.
▶ The location at which the charger is used should be clean and cool but protected from frost.
*440647*
Printed: 03.12.2018 | Doc-Nr: PUB / 5069448 / 000 / 02
440647
C 7
01
English 9