Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Receiver for Wireless Microphone
These instructions are intended for users without
any specific technical knowledge Please read
the instructions carefully prior to operation and
keep them for later reference
All control elements and connections de-
scribed can be found on page 2; for an overview
of the functions in the setting mode, please refer
to page 27
1 Overview
1 Receiving antennas
2 Ultrasonic transmitter for the REMOSET
function
3 Volume control VOL
4 Button REMOSET to transfer the settings
from the receiver to the wireless micro-
phone / pocket transmitter
5 LED indicators RF (radio frequency) for the
strength of the radio signal received
6 LED indicators AF (audio frequency) for the
volume of the microphone signal received
7 Display
Indication Meaning
... MHz
G ... CH ... group number or channel number
A
B
ATT.ON
MUTE
SQ ...
Note: When the batteries of the wireless micro-
phone / pocket transmitter are almost discharged,
the display illumination will change to red
10
transmission frequency
key lock activated
diversity indication A or B: indicates
which of the two receiver sections re-
ceives the radio signal of higher strength;
there will be no indication when the
receiver is muted
status of the batteries in the wireless
microphone/pocket transmitter
level of the XLR output (14) attenuated
by 20 dB
the receiver is muted
– when no radio signal is received or
when the radio signal received is poor
– when the wireless microphone / pocket
transmitter is muted
value adjusted for interference suppres-
sion (squelch)
8 Button SET to call up the setting mode (keep
the button pressed for 2 seconds), to select a
setting and to save a setting (
9 Buttons
and
setting mode
10 Button
to switch the receiver on (briefly
press the button) or to switch it off (keep
the button pressed for 2 seconds)
11 Strain relief for the cable of the power sup-
ply unit
12 Power supply jack to connect the power
supply unit provided
13 Audio output (6 3 mm, unbalanced) with
line level
14 Audio output (XLR, unbalanced) with line
level or, when level attenuation is activated,
with microphone level
15 BNC jacks for the two antennas provided (1)

2 Safety Notes

The units (receiver and power supply unit) cor-
respond to all relevant directives of the EU and
are therefore marked with
WARNING The power supply unit uses dan-
gerous mains voltage Leave ser-
vicing to skilled personnel only
Risk of electric shock!
The units are suitable for indoor use only Pro-
tect them against dripping water, splash water
and high air humidity The admissible ambient
temperature range is 0 – 40 °C
Do not place any vessel filled with liquid on
the receiver, e g a drinking glass
Immediately disconnect the power supply unit
from the socket
1 if the receiver or the power supply unit is
visibly damaged,
2 if a defect might have occurred after the
unit was dropped or suffered a similar ac-
cident
3 if malfunctions occur
In any case the units must be repaired by
skilled personnel
For cleaning only use a dry, soft cloth; never
use chemicals or water
No guarantee claims for the unit and no
liability for any resulting personal damage or
chapter 4 3)
to make changes in the

Publicité

Table des Matières
loading

Table des Matières