Publicité
Les langues disponibles
Les langues disponibles
ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting 3-Wire Connection: Optional
Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground conductor to
neutral wire.
Connecting Neutral Wire
1. Remove center terminal block screw. Also remove neutral
3. Connect remaining wires to outer terminal block.
ground wire by removing external ground conductor screw.
2. Connect neutral wire and neutral wire of power supply cord/
4, Connect a separate copper ground wire from the external
cable to center terminal block.
ground conductor to an adequate ground.
eT
LEVELING
Leveling your dryer properly reduces excess noise and vibration.
A WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Not Level
LEVEL
Not Level
1. Remove cardboard from beneath dryer. Place a level on top
edges of dryer, checking each side and front. If not level, tip
dryer and adjust legs up or down as shown in Steps 3 and 4,
repeating as necessary.
[
1
22
Publicité
