Publicité
Les langues disponibles
Les langues disponibles
Waveguide Cover
MICROWAVE WALL OVEN INSTALLATION INSTRUCTIONS
IMPORTANT NOTES TO
THE INSTALLER
1. Read all instructions contained in these installation
instructions before installing the Microwave Wall Oven.
This oven can be built into a cabinet or wall by itself or
above any electric wall oven or warming drawer.
Remove all packing material from inside the oven cavity
before connecting the electrical supply to the Microwave
Wall Oven. DO NOT REMOVE THE WAVEGUIDE COVER,
which is located on the cavity ceiling. See Figure 2A.
{5
IMPORTANT SAFETY
INSTRUCTIONS
fA, CAUTION
Never.use your appliance for warming or heating
the room. Prolonged use of the oven without adequate
ventilation.can.be dangerous.
Carpentry
Refer to Figure 1 for the dimensions required for your
appliance, and the space necessary to install the oven. The
oven support surface should be solid plywood or similar
material, the surface must be level from side to side and
Door Latch
Oven Cavity
|
SEE,
rr—"('"CCN.UCUOA.. h
from front to rear.
Door Seals
and Sealing
Electrical Requirements
urfaces
Hinge —_
The appliance operates on a 120 volt, 60 Hz electrical
Safety
-
supply with a separate ground wire.
Provide a separate
Figure 2A
Figure 2B
. Remove the 2 shipping duct supports (see Figure 2B) by
removing the 2 screws securing each side. Reinsert 2
screws (each side) to secure the stainless cover.
Remove the feature sticker, if there is one, from the
outside of the door.
. Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealling surfaces,
broken or loose door hinges and latches and dent
inside the cavity or on the door.
A\ WARNING
lf. there-is any:damage,
DO-NOT-operate-the
oven and-contact-your dealer-or ELECTROLUX
AUTHORIZED. SERVICER.
6. Observe all governing codes and local ordinances.
7.
Be sure to leave these instructions with the consumer.
IMPORTANT NOTE TO
THE CONSUMER
Keep these instructions with your Owner's Guide for future
reference.
E2
circuit with a fuse or circuit breaker rated for 15 amps.
Observe all governing codes and local ordinances
/\, CAUTION
To.prevent: damage to the oven. control, during cold
temperature.
weather,
wait at-least three (3)-hours
after receiving this oven-before supplying power-to
the appliance. This will. prevent possible damage to -the
built-in oven control at power-on.
Cabinet Installation
NANA INe
The Microwave Wall Oven can tip when the door
is open. The Anti-Tip brackets.supplied with the
Microwave Wall Oven
must be attached to the
cabinet.and the appliance to prevent tipping of
the unit and injury to persons:
ANTI-TIP BRACKETS
INSTALLATION
INSTRUCTIONS
1. Unpack the Microwave Wall Oven
and find the 2
Anti-Tip brackets and screws included in the literature
package.
2. Install the Anti-Tip bracket in the cabinet as shown
on Figure 3. Note: To prevent damage to cabinet, it
is recommended
to drill "/16" (0.16 cm) diameter pilot
holes before installing the Anti-Tip brackets.
Publicité
