Publicité
Les langues disponibles
Les langues disponibles
Dishwasher
Dispenser
&
Detergents
(continued)
Rinse Aid
Rinse aid greatly
improves
drying and
reduces water spots and filming.
Water
"sheets" off dishes rather than forming water
droplets that cling and leave spots.
A dispenser,
located
next to the detergent
cup,
automatically
releases a measured
amount of
rinse aid during the last rinse. If spotting
and
poor drying are problems,
increase the
amount
of rinse aid dispensed
by rotating the
dial to a higher number.
The dial is located
under the dispenser
cap. The indicator will be
dark when full and will show clear when it is
time to refill.
To add liquid rinse aid, turn dispenser
cap 1/4
turn counterclockwise
and lift out. Pour in rinse
aid until liquid touches the indicated
fill level.
Replace cap.
Do not overfill since this can cause
oversudsing.
Wipe up any spills with a damp
cloth.
The dispenser
holds enough for 35 to 140
washes, depending
on setting.
Factors
Affecting
Performance
Water
Temperature
Hot water is needed
for best dishwashing
and
drying results. Water entering dishwasher should
be 120°F to give satisfactory results. Improved
performance
may be obtained
by raising
water
temperature to 140°F. Water temperature should
not exceed 160°F. Check your water heater for
proper temperature.
To check water
temperature
entering
dishwasher,
turn on hot water faucet nearest dishwasher for
several minutes to clear cool water from water
pipes.
Place
a glass
under faucet and use
a candy
or meat thermometer to check
temperature
of the
water collected.
If temperature
is below
120°F (49°C), have a
qualified
person
raise the hot water heater
thermostat
setting.
Do not operate
the dishwasher
during or just after
other heavy use of hot water, such as laundry
or
bathing.
Important:
Before
starting
a cycle, run hot
water through
faucet
to clear cool water from
pipe.
Dispenser
Opening
Indicator
b>
Less
Dispenser
Cap
More
J
Adjustable
setting
10
Publicité
