Samsung NX58565 Serie Mode D'emploi page 65

CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
• The burner head can be blocked by food or dust. Clean the head if it appears
blocked. If you clean the head with water, assemble it only after it is
completely dry. If the head is wet, it might prevent the burners from igniting.
• To avoid falling down the grates, make sure to remove both sides grates first.
• Do not attempt to remove center oval burner cap from the head.
Precise Simmer Burner (RR) Precise Simmer Burner (RR)
Flat surface Flat surface Concave line Concave line
7. Set all burner heads on top of the
manifold valves in the same location
you removed them from. The hole on
the side of the burner heads goes over
the electrodes. The burner heads are
correctly installed when they are flat on
the top of the manifold valves.
8. Set all burner caps on top of the burner
heads.
These also need to be flat on top of the
burner heads to ensure proper and safe
operation.
NOTE
The caps on Precise simmer burner (RR)
and inside Double-ring Burner (RF) can be
interchangeably used.
9. Replace burner grates on top of the
range cooktop.
10. Push in and turn each surface burner
control knob to the LITE position, let
each burner light, and then set each
control knob back to a burner setting
to make sure each burner operates
properly.
English 65