Samsung NX58565 Serie Mode D'emploi page 75

PROBLEM POSSIBLE CAUSE
You have a function error
The oven
control beeps code. See the Troubleshooting
and displays and information codes chart
an error code. on page 80.
All burners do The power cord is not
not light. plugged into the electrical
outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
The gas supply is not properly
connected or turned on.
Surface The control knob is not set
burners do not properly.
light.
The burner caps are not in
place.
The burner base is misaligned.
SOLUTION
Press the OFF/CLEAR pad
and restart the oven. If the
problem persists, disconnect
all power to the range for at
least 30 seconds and then
reconnect the power. If this
does not solve the problem,
call for service.
Make sure the electrical
plug is plugged into a live,
properly grounded outlet.
Replace the fuse or reset the
circuit breaker.
See the Installation
Instructions that came with
your range.
Push in the control knob and
turn it to the LITE position.
Clean the electrodes.
Put the burner cap on the
burner head. Align the burner
base.
PROBLEM POSSIBLE CAUSE
The control knob has been left
Surface burner
clicks during in the LITE position.
operation.
The burners Surface burner components
do not burn and caps are not assembled
evenly. correctly and level.
Surface burners are dirty.
Very large or Wrong orifice is assembled.
yellow surface
burner flames.
The oven door lock is turned
Surface
burners light on.
but oven
burners do not
light.
Gas Pressure Regulator
shut off switch is in the 'off
position.
SOLUTION
After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks,
contact a service technician.
See page 64.
Clean surface burner
components. (See pages 64
and 65.)
Contact your installer. Check
the burner orifice size and
contact your installer if you
have the wrong orifice. Check
the LP gas conversion.
The display will show the
Lock icon. Hold the oven door
open and press the START/
SET pad for 3 seconds. The
oven will beep and the Lock
icon will turn off.
Call a qualified service
technician.
English 75