Publicité
Les langues disponibles
Les langues disponibles
4 4
Pairing the Headset with the Camera (Optional)
The camera and headset come already paired. However, if the headset does not work or you are
replacing it with another headset, follow the steps below to pair the headset with the camera.
1. You need to set up the camera, turn on the computer, and charge the headset. (See the previous
sections for more information.)
2. Make sure the headset is turned off (headset LED is off).
Press and hold the Multi-function button on the headset
for seven seconds until the headset LED flashes red-blue.
3. Release the Multi-function button. The LED will flash for
60 seconds, indicating the headset is in pairing mode.
4. Launch the camera software installed on the computer,
and then select the Audio tab.
5. Select the Private Mode for using the headset. Click the link
to be guided through the headset pairing process.
6. Follow the on-screen instructions.
7. When paired, the camera's Bluetooth link LED blinks slowly and the headset's LED blinks blue every
three seconds.
8. Verify successful headset-camera pairing by pressing the headset's Multi-function button once.
The camera's Bluetooth Link LED should turn on (see "Camera and Headset LEDs" for more
information). Press the Multi-function button again and the Bluetooth LInk LED will blink slowly.
9. If pairing does not occur, turn off the camera by unplugging the power, turn off the headset,
wait 10 seconds, turn the headset and camera back on, and repeat steps 2-8.
10. Place the headset back in its cradle when not in use.
Note If more than one ViewPort camera is used in the same general area (same room or
office area), please make sure to pair each device separately. Pairing various headsets
and cameras simultaneously may result in a mismatch between paired devices.
4
English
Multi-function
button
LED
Publicité
