Publicité
Les langues disponibles
Les langues disponibles
3
GB
WWW.PlanDeGraissage.ORG
FRONT BRAKE
FRONT BRAKE
FRONT BRAKE
FRONT BRAKE
FRONT BRAKE
Check
Check
Check
Check
Check
To check the front brake for wear, simply
observe the caliper from the front, where
it is possible to see the ends of the two
pads. These pads should have at Ieast a
2 mm Iayer of Iining. If this layer is thinner
than 2 mm, replace the pads immediately.
Note:
Note:
Note:
Note:
Note:
Observe the times given on the chart on
pag. 62 when performing the check.
Replacement
Replacement
Replacement
Replacement
Replacement
To replace the pads, proceed as follows:
•Disassemble the disk cover and the
caliper by unscrewing the two screws A A A A A
and releasing the screw B B B B B
•Slide the split pin C C C C C
•Unscrew the screw B B B B B
•Remove the pads D D D D D and replace them
•To reassemble, proceed in the reverse
order.
Note:
Note:
Note:
Note:
Note:
To avoid braking problems, pay particular
attention to the correct reassembly of the
split pins.
If the brake disk is removed, apply
If the brake disk is removed, apply
If the brake disk is removed, apply
If the brake disk is removed, apply
If the brake disk is removed, apply
Loctite
Loctite
Loctite
Loctite
Loctite
to
to
to
to
to
the
the
the
the
the
reassembling.
reassembling.
reassembling.
reassembling.
reassembling.
58
screws
screws
screws
screws
screws
when
when
when
when
when
Publicité
