Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION FOR 60 AND 78 CM WIDE HOBS
Connect the hob according to the wiring diagram.
This device is set for 2 x 1 phase (230V) and uses a so-called 5-pin Perilex plug. These groups in the meter must be secured with at
least 16 amps each. The connection cable is supllied without a Perilex plug.
ATTENTION : this hob is not suited for a different wiring diagram.
THE FITTING OF THE APPLIANCE
• Check that the cabinet and the cut-out meet the dimension and ventilation requirements.
• Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic worktops
with sealing varnish if necessary, to prevent moisture causing the worktop to swell.
• Lay the hob upside down on the worktop.
• Fit the connecting cable to the appliance in compliance with requirements.
• Remove the protective layer from the sealing tape and apply the tape on the edge of the glass plate. Make sure to apply the
tape to the glass and not on the metal part. Do not stick the tape around the corners, but cut 4 separate pieces to seal the
corners well. Attention: any damage that occurs when not applying the tape has concequences for the warranty.
• Fit the supllied mounting brackets on the appliance.
• Turn the hob over and lay it in the recess.
• Connect the appliance to the mains. The appliance is ready for use.
• Check that it works properly. If the appliance has been wrongly connected either a bleep will sound or an error code will appear
on the displays.
REMOVING THE HOB
Disconnect the hob from the mains. Remove the hob by pushing it upwards from the bottom. Attention! Beware of damage to
the appliance! Do not try to remove it from the top.
31
English
•
Publicité
