Polaris FREEDOM EB37 Serie Manuel Du Propriétaire page 9

Polaris FREEDOM Cordless Robotic Cleaner | Owner's Manual
® ™
3.5 Start Cleaner
1. Select Cleaning Mode using the slider by
sliding and releasing to the left or by using
the App.
Floor/Wall
Product or App
Floor Product or App
SMART
Waterline
Figure 6. Slide and Release Left to Select Mode
NOTE: Choose Floor Only mode to clean with Pool
Cover on.
2. Start the cleaner using the slider by sliding and
releasing to the right or use the App.
Figure 7. Slide and Release Right to Start
3. The cleaner does not begin moving until it
senses water. A blinking blue LED light means
it is ready to clean.
3.6 Submerge the Cleaner
1. At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside.
2.5 hrs
1.5 hrs
In App Calculated
In App 0:45 min
1
Figure 8. Submerge the Cleaner Vertically
2. Wait for bubbles to stop completely, then let
the cleaner sink to the bottom of the pool.
2
Figure 9. Cleaner Sinking to the Bottom of the Pool
3. Cleaning cycle will start as soon as the cleaner
detects the pool water.
WARNING
Do not enter pool while the robotic cleaner is in water.
3.7 Removal
1. During the last 10 minutes of the cycle, the
cleaner will climb to different walls and wait at
the waterline. Remove using the handle. Water
will expel to make it lighter (Not available in
Floor Only mode). If the cleaner is not removed
at the waterline, it will return to the floor at the
end of the cycle.
NOTE: If connected to the iAquaLink
notifications will be sent to your mobile device
during this time to alert you to remove the
cleaner while waiting.
ENGLISH
® app, push
Page 9