Publicité
Les langues disponibles
Les langues disponibles
Polaris
FREEDOM
Cordless Robotic Cleaner | Owner's Manual
®
™
you previously set up an iAquaLink account, click
Log In to access your systems.
Complete all required fields in the Account Setup
page and agree to the Terms and Conditions.
WARNING
Do not enter pool while the robotic cleaner is in water.
4.3
Configure the System
1.
On the My Systems page, click + in the upper
right-hand corner to add a system.
2.
Choose "Robotic Cleaner" from the list and
choose your model type.
3.
Follow on screen prompts to pair your cleaner.
4.
Slide the slider right and HOLD for ten
seconds to put the cleaner in Pairing Mode.
Wi-Fi LED Indicates Connection Status
BLINKING - pairing
SOLID - connected to internet
Figure 14. Slide and Hold Right to Start
5.
Follow on-screen prompts to add your cleaner
and connect to your home router.
NOTE: If you have problems connecting, the Wi-Fi
signal may not be strong enough next to
the pool. Try placing the charging station in
another location closer to your home router
(see iAquaLink Troubleshooting section.)
Section 5. iAquaLink
IMPORTANT
WiFi signals cannot travel underwater. Most app functions are therefore
not available during a cleaning cycle. Place the cleaner back on the
charging stand to reconnect to the WiFi.
WARNING
Do not enter pool while the robotic cleaner is in water.
5.1
iAquaLink
Control Home Screen
®
App function and design is subject to change.
Start Cleaning
Clean Mode
Battery Charge Status
Green Charged: Fully charged
Green Charging: Ready for use
Orange Charging
Orange Partially Charged
5.2
Set Cleaning Mode
1.
From the main screen, select Cleaning Mode
to view options.
2.
Select Cleaning Mode. The factory default
cleaning mode is Floor/Wall.
3.
From the Home screen, press the Start button
to begin cycle. The cleaner will start when it
detects water and will cancel the cycle if not
submerged after 5 minutes.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10 minutes). During this time,
the cleaner does not climb to the waterline.
ENGLISH
Control
®
Page 11
Publicité
