Polaris FREEDOM EB37 Serie Manuel Du Propriétaire page 19

Polaris FREEDOM Cordless Robotic Cleaner | Owner's Manual
® ™
7.3 Cleaner Error Codes
On/
Blinking Red
Off
Error Display in the
# iAquaLink ® App
10 Communication
error
14 Motor block error
2 & 3 Traction motor
left/right
Drive motor
consumption
5 & 6
left/right
7 Cleaner floating
8
Cleaner out of the
water
Pump motor
4 & 1
12 Firmware Update
Error
Solutions
• The cleaner board is under power but
does not respond.
• Contact your retailer for a diagnostic
review or contact Technical Support at
1.800.822.7933.
• Check that debris is not preventing the
brushes or tracks from moving freely.
• Rotate each wheel by a quarter of a
turn in the same direction until it rotates
smoothly. Repeat turning wheels in
the opposite direction until rotation is
smooth.
• Contact your retailer for a diagnostic
review or contact Technical Support at
1.800.822.7933.
• Thoroughly clean the filter canister.
• Restart the cycle, then submerge
cleaner in the water and shake to
release air bubbles.
• Contact your retailer for a diagnostic
review or contact Technical Support at
1.800.822.7933.
• Turn off the cleaner using the slider
by sliding to the left and hold for 20
seconds while off of the charging
station. No LEDs will be illuminated.
• Check for small debris or hair in the fan
impeller.
• Thoroughly clean the filter canister.
• Contact your retailer for a diagnostic
review or contact Technical Support at
1.800.822.7933.
®
• Close the iAquaLink
• Check that the cleaner is connected
to the Wi-Fi network (the LED is solid
blue).
• If the indicatoris not steady, open the
iAquaLink™ app, select the cleaner and
click on "Update".
ENGLISH
app.
Page 19