LD Systems MAILA SUB Manuel D'utilisation page 11

SERVICE
HINTS
• When the subwoofer is switched on, all settings such as PRESET and EQUALIZER are loaded as they
were before the subwoofer was switched off. The subwoofer is ready for operation after a short time.
• After about 30 seconds without any input via the turn-push encoder, the display system exitsLevels in
the menu structure and the main display with the selection VOLUME is automatically displayed.
MAIN DISPLAY
In normal operation, the main display is activated, showing VOLUME with the current value, the set
delay and the activated preset. The Bluetooth status, the volume level (LVL) and the amplification (VOL)
are displayed graphically. The level reduction by the integrated limiter is displayed under GR
(Gain Reduction). If the red CLIP indicator lights up, this signals that the input stage is being operated
above the distortion limit. Reduce the output level of the feed device (e.g. mixing console) until the
CLIP indicator no longer lights up and the subwoofer reproduces audio signals without distortion.
<
VOLUME
CLIP
LVL
+0.0
<
VOLUME
+0.0
<
VOLUME
VOLUME
Adjust the level of the amplifier module by using the encoder directly from the main display, or select
+0.0
VOLUME from the main menu, confirm and then set the desired value from -40 dB to +10 dB.
LVL
LVL
Mute: Press the encoder for about 2 seconds to mute the subwoofer and again for about 2 seconds to
unmute it (at all menu levels).
LVL
LVL
0 ms
105 Hz
GR VOL
0
ms
105 Hz
CLIP
LVL GR VOL
0 ms
105 Hz
<
CLIP
LVL GR VOL
VOL
LVL VOL
LVL VOL
VOL
LVL VOL
LVL VOL
VOL
LVL VOL
LVL VOL
VOL
LVL VOL
VOLUME
0 ms
105 Hz
LVL VOL
+0.0
<
VOLUME
+0.0
<
VOLUME
+0.0
LVL VOL
0 ms
105
Hz
LVL VOL
0 ms
105 Hz
LVL VOL
LVL VOL
LVL VOL
11