Wolf ICBDD30 Instructions D'installation page 8

W O L F
I N S TA L L AT I O N
Wolf downdraft Model ICBDD30 will fit most
762 mm wide cabinets, Model ICBDD36 will fit
most 914 mm wide cabinets and Model
ICBDD45 will fit most 1156 mm wide cabinets.
It is recommended that oversized cabinets be
used for easier installation. Cabinet backs may
need to be removed.
Wolf downdraft ventilation systems can be
mounted in an island, peninsula or standard
wall location.
The illustration below provides installation
dimensions for all Wolf downdraft models.
Pay careful attention to the areas of potential
interference as noted in the illustration.
44 mm
BACK EDGE
OF COOKTOP
TO INSIDE OF
CABINET BACK
8.7 mm
745 mm
COUNTERTOP
TO BOTTOM OF
AIR BOX
Downdraft installation dimensions
8
D O W N D R A F T V E N T I L AT I O N S Y S T E M S
S P E C I F I C AT I O N S
638 mm
min
min OF FLAT COUNTERTOP
16 mm
489 mm
*
COOKTOP CUT-OUT
DEPTH
60 mm
54 mm
83 mm
92
mm
127 457
mm mm
181 mm
610 mm
min
CABINET DEPTH
*
AREAS OF POTENTIAL INTERFERENCE
IMPORTANT NOTE: To install a downdraft
system and a Wolf cooktop, you must allow for
a minimum 638 mm flat counter space from
front to back. A countertop with a raised lip or
backsplash may not allow enough space for
proper installation. 60 mm of flat countertop is
required behind the cooktop and 44 mm is
necessary between the back edge of the
cooktop and inside of cabinet back.
If downdraft Model ICBDD30 is installed in
combination with with two cooktops or inte-
grated modules, an integrated module support
(8603386) for downdraft ventilation is required.
The integrated module support is not required
for Model ICBDD45.
*
64 mm
min
WITH NO
RAISED LIP *
197 mm
914 mm