Wolf ICBDD30 Instructions D'installation page 10

W O L F
D O W N D R A F T
Set the downdraft into the opening. Extend
the leveling brackets to the floor of the
cabinet so the downdraft sits straight.
NOTE: The leveling brackets can be
removed and reattached in other positions.
The flange of the leveling bracket may have
to face inward in tight cabinet installations.
Refer to the illustration below.
Secure the downdraft to the countertop by
holding the downdraft against the back of
the countertop cut-out and tightening the
two mounting screws (one on each end of
unit) on the underside of the countertop.
Screw the leveling brackets to the bottom
of the cabinet. Tighten the screws holding
the leveling brackets to unit on each side.
10
D O W N D R A F T V E N T I L AT I O N S Y S T E M S
I N S TA L L AT I O N C O N T R O L M O D U L E
To reduce the risk of burns or ignition of
clothing by reaching across burners,
control module must be mounted at least
76 mm from edge of cooktop cut-out.
The remote-mounted control module and top
cover are included with the downdraft. Also
included are mounting brackets, RJ45 connec-
tor and mounting hardware.
The control module can be located anywhere
within reach of the 3 m power cable and a
minimum of 76 mm from edge of cooktop
cut-out. The remote-mounted control module
is 60 mm x 168 mm and can be positioned
horizontally or vertically in the countertop.
IMPORTANT NOTE: Do not place the module
where it will be in the way of cooking, where
hot pans may be placed or where hot liquids
could be spilled on the controls.
leveling bracket –
flange facing out
leveling bracket – flange facing in
Downdraft mounting brackets
mounting screws