Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE BAFFLES ON THE INDUCTION HOB
1. Put the induction hob on a smooth surface with the glass plate pointing down.
Caution:
Make sure not to scratch or break the glass.
2. Fasten the baffles on the sides of the induction hob. Refer to the figure for the positions of the baffles.
PREPARE THE HOOD FOR ASSEMBLY
1. Put the connection cable in the cable holder.
2. Put the hood gasket on the hood.
Caution:
•
Make sure to use the correct gasket.
•
Make sure that the gasket is correctly attached before you continue to the next step.
ASSEMBLE THE HOB AND THE HOOD
1. Attach the connection cable of the hood to the hob.
2. Put the hood on the hob.
3. Make sure that the connection feet align with the holes in the hob.
4. Tighten the screws in the connection feet to attach the hood to the hob.
WIRE THE ELECTRICAL CONNECTION BLOCK
(Figure 10)
1. Obey the safety instructions for the electrical connection. Refer to section
connection
.
2. You can connect the appliance to the mains supply with a single-phase, two-phase or three-phase electric
connection.
•
Refer to Figure A for the single-phase wiring diagram.
•
Refer to Figure B for the two-phase wiring diagram.
•
Refer to Figure C for the three-phase wiring diagram.
3. Add bridges for one- and three-phase connections.
4. Make sure that the wiring of the electrical connection block corresponds with the data in the wiring diagram.
5. Make sure that the chosen phase wiring complies with the technical system in the domestic meter cupboard.
6. Make sure that the groups in the meter cupboard are protected with at least a 16 Ampere fuse.
7. Make sure that the chosen phase wiring complies with the connecting power cable.
PUT THE STRAIN RELIEF ON THE ELECTRICAL CONNECTION BLOCK
1. Put the cover with the strain relief over the electrical connection block and power cable
2. Tighten the screws to fasten the strain relief.
SHORTEN THE DUCT ADAPTER
1. Measure the distance L1. That is the distance between the back wall and the front side of the
cavity in the worktop.
2. Measure the distance L2. That is the depth of the appliance with the duct adapter and the
corner pipe.
3. Calculate the distance X. That is L2 minus L1.
4. If the distance X is less than 5 mm, cut the duct adapter at distanceX to shorten it. Use the handsaw.
30
•
English
(Figure 12)
(Figure 13)
(Figure 14)
Safety instructions for the electrical
(Figure 15)
(Figure 16)
Publicité
