Uline H-10306 Instructions De Montage page 7

4. Align holes on L-bracket (F) with pre-drilled holes in
credenza top panel (1) on the storage cabinet side.
Insert two M3 x 12 mm screws (F) and attach using
a Phillips screwdriver or drill. Align holes on door
plug (K) with pre-drilled holes in top panel and
gently tap with rubber mallet to insert. Repeat on
opposite side if assembling H-10306 double cabinet
credenza. (See Figure 13)
K
Figure 13
5. Attach credenza top panel to frame legs using four
M6 x 55 mm bolts (P). (See Figure 14)
P
Figure 14
6. Attach credenza top panel to support beams in
cabinets using 16 M6 x 30 mm bolts (C).
(See Figure 15)
Figure 15
PAGE 7 OF 24
ASSEMBLY CONTINUED
F
C
Steps 7-9 only apply if assembling the H-10307
lateral file and cabinet credenza. Otherwise,
proceed to step 10.
7. Reattach top drawer of lateral file. (See Figure 16)
Figure 16
8. To hang files from side to side, attach one file
clip (L) to each side of drawer and insert one long
metal bar (M). (See Figure 17)
Figure 17
9. To hang files from front to back, attach two file
clips (L) to back of drawer and two to front of drawer
and insert two short metal bars (N). (See Figure 18)
N
L
Figure 18
M
L
0223 IH-10306