Uline H-10306 Instructions De Montage page 6

3. Remove top panel (1) by taking out eight
M6 x 30 mm bolts (C) using Phillips screwdriver.
Save bolts for credenza top frame construction. Top
panel will not be used and can be discarded. Set
assembled lateral file cabinet aside. (See Figure 10)
Figure 10
CREDENZA ASSEMBLY
Open H-10308 carton to assemble credenza
in steps 1-7.
NOTE: If assembling H-10306 double cabinet
credenza, two storage cabinets will be
attached together. The same instructions will
be followed for steps 1-6. Figures only show a
lateral file and cabinet credenza.
NOTE: Position cabinets near desired location.
It is difficult to move the credenza when fully
assembled.
1. With second person, carefully set cabinets on back.
NOTE: If assembling H-10307 lateral file and
cabinet credenza, cabinets can be configured
on either side. Figures show lateral file on left
and storage cabinet on right.
PAGE 6 OF 24
ASSEMBLY CONTINUED
1
C
2. Align two flat brackets (Q) with holes on underside
of cabinets. Insert four adjustable glides (A) through
brackets and tighten to connect lateral file and
storage cabinet. (See Figure 11)
Figure 11
3. Position steel legs (2) on sides of cabinets. Align
flat brackets (Q) with underside of cabinets and
steel leg. Insert eight adjustable glides (A) through
brackets and tighten to connect cabinets to steel
legs. With three people, carefully lift both cabinets
upright simultaneously. (See Figure 12)
Figure 12
2
Q
A
Q
A
0223 IH-10306