Uline H-10306 Instructions De Montage page 5

9. Using two people, hold door panel in line with
side panel. Attach hinge (J) to inside of side panel
using four M3.5 x 14 mm screws (J). Repeat for three
remaining hinges. (See Figure 6)
Figure 6
8
10. Once door panels are attached, hinges may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 7)
Figure 7
Side
Door
Panel
Door Depth
11. Storage cabinet top from H-10295 carton will not be
used and can be discarded. Set assembled storage
cabinet aside.
PAGE 5 OF 24
ASSEMBLY CONTINUED
J
9
Side
Door
Panel
Door Angle
STOP! If assembling H-10306 double cabinet
credenza, repeat storage cabinet assembly
to build second cabinet. Then proceed to
credenza assembly on page 6.
If assembling H-10307 lateral file and cabinet
credenza, open H-10303 and follow lateral file
assembly below.
LATERAL FILE ASSEMBLY
1. Remove handle (B) mounted inside drawer and use
same bolts (M4 x 34 mm) to attach handle to front of
drawer. Repeat for all handles. (See Figure 8)
Figure 8
2. Remove top drawer by pressing on plastic tabs on
drawer slides and pulling out. (See Figure 9)
Figure 9
B
0223 IH-10306