Uline H-10751 Mode D'emploi

H-10751, H-10752
CLEANROOM GOWNING
BENCH
TOOLS NEEDED
Drill 1/2" Masonry Drill Bit
Bench Top x 1
1. Lay bench top on a smooth, non-marring surface
with leg mounts face up. Align legs with leg mounts
on bench top. (See Figure 1)
Figure 1
1. Position bench at desired location. Using pre-drilled
holes in leg bases as templates, mark each hole
location.
2. Using a 1/2" masonry drill bit, drill holes at all marked
locations approximately 2" deep.
3. Insert anchor bolt and sleeve into hole. Ensure sleeve
is flush with floor and bolt threads are above floor
level. Repeat for remaining anchors.
4. Align holes in leg base with anchors in concrete.
Place washer and nut onto threaded portion of
anchor bolt. Tighten using Drill and 14mm nut
driver bit. Repeat for remaining holes. (See Figure 3)
PAGE 1 OF 3
1-800-295-5510
uline.com
14 mm Nut Driver Bit
PARTS
Leg x 2
ASSEMBLY
CONCRETE ANCHORING
Set Screw x 8
2. Secure legs to bench top with set screws. Repeat for
remaining leg. (See Figures 1-2)
Figure 2
Nut
Lock Washer
Washer
Anchor Sleeve
Anchor Bolt
Figure 3
Para Español, vea página 2.
Pour le français, consulter la page 3.
Anchor Hardware Set x 8
(Anchor Bolt, Anchor Sleeve, Washer,
Lock Washer and Nut)
Leg Base
0123 IH-10751