Uline H-10306 Instructions De Montage page 4

3. Install seven cam lock pins (D) and six dowels (G)
in left side panel (1). Insert seven cam locks (E) into
corresponding holes in back panel (5), bottom
panel (4), skirt panel (6) and top support beams (10).
Fit left side panel together with back panel, bottom
panel, skirt panel and top support beams and
tighten cam locks. Repeat for right side panel (2).
(See Figure 3)
Figure 3
5
10
D
4. Set cabinet upright. Insert four shelf dowels (H) into
desired hole locations in side panels (1, 2). Place
shelf (7) inside cabinet and ensure shelf supports
lower onto shelf dowels. Tighten shelf supports in
underside of shelves for a secure fit. (See Figure 4)
Figure 4
1
PAGE 4 OF 24
ASSEMBLY CONTINUED
4
E
G
1
7
2
4
H
5. Place left door (8) and right door (9) panels on a
smooth, non-marring surface to prevent scratching.
Align holes in hinge (J) with pre-drilled holes in door
panels. Insert two M4 x 10 mm bolts (J) and tighten.
Repeat for three remaining hinges.
(See Figure 5)
6. Attach handles (B) to the outside of the door panels
using four M4 x 22 mm bolts (B). (See Figure 5)
7. Align holes on S-bracket (F) with pre-drilled holes in
top of left door (8). Insert two M3 x 12 mm screws (F)
and tighten. (See Figure 5)
8. Align holes on lock (F) with pre-drilled holes in right
6
door (9). Insert two M3.5 x 14 mm screws (F) and
tighten. (See Figure 5)
Figure 5
J
9
8
F
B
F
0223 IH-10306