To store the product vertically on the supplied
hook
WARNING:
the wall with the supplied hook.
1. Install the supplied hook. Refer to
on the wall on page 14 .
2. Set the product in storage position. Refer to
the product in storage position on page 20 .
3. Lift the product by the lifting points on the handle.
(Fig. 49)
WARNING:
by the cutting cover. The blade is very
sharp and cuts can easily occur.
4. Hang the product vertically on the supplied hook.
To install the hook on the wall on page 14 .
Refer to
(Fig. 51)
5. Make sure that the product hangs correctly and is
stable on the 2 rods of the hook.
6. Attach the grass catcher. Refer to
grass catcher on page 21 .
To attach the grass catcher
1. Attach the grass catcher to the groove on the front of
the product. (Fig. 52)
Technical data
Cutting motor
Motor type
Motor speed – Nominal, rpm
Motor speed – High load, rpm
Motor output – max. kW
Motor output – Nominal, kW
Drive motor
Motor output – Nominal, kW
Self walk speed, km/h
Speed adjustment levels
Weight
Weight without bag (excl. battery), kg
Weight with bag (incl. 1x P4A 18-B72), kg
1848 - 004 - 17.08.2023
Only hang the product on
To install the hook
To set
Do not lift the product
To attach the
Technical data
2. Push the lower part of the grass catcher against the
lifting point until you hear a click. (Fig. 53)
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise
result through the incorrect waste management of this
product. For more detailed information about recycling
this product, contact your municipality, your domestic
waste service or the shop from where you purchased
the product.
(Fig. 54)
Only for EU countries: According to the Directive
2006/66/EC, defective or used battery packs/batteries,
must be collected separately and disposed of in an
environmentally correct manner.
Only for United Kingdom: According to the Waste
Batteries and Accumulators Regulations 2009 (SI
2009/890) (as amended), battery packs/batteries that
are no longer usable must be collected separately and
disposed of in an environmentally friendly manner.
Aspire LC34-P4A
BLDC (brushless) 18V
3000
3500
0.7
0.5
N/A
N/A
N/A
11.5
13.5
21