Husqvarna Aspire LC34-P4A Manuel D'utilisation page 15

To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
To set the product in operation position
1. Turn the handle knobs to the unlocked position. (Fig.
31)
2. Fold the handle up until you hear a click. (Fig. 32)
CAUTION:
is not too much tension in the cables.
Too much tension can cause damage
to the cable if the handle is folded into
transport position.
WARNING:
handle is fully folded up and in locked
position.
3. Adjust the handle height. Refer to
handle height on page 14 .
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 33)
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery in the product
1848 - 004 - 17.08.2023
Make sure that there
Make sure that the
To adjust the
Do not set the cutting height
Before you use the battery,
Ambient temperature
0 °C – +40 °C
Charging of the bat-
tery
To charge the battery
Charge the battery before the first use.
Note:
The charging process is only possible when
the temperature of the battery is within the permitted
charging temperature range (0–45 °C).
1. Connect the power cord for the battery charger in a
grounded mains.
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 34)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Battery status LED on the battery charger
The red LED (A) and the green LED (B) on
battery charger show the battery status. Refer to
Troubleshooting of the battery charger on page 18 .
(Fig. 35)
LED
The green LED flashes
quickly.
The green LED flashes
slowly.
The green LED is on.
The red LED is on.
The red LED flashes
quickly.
Ambient temperature
0 °C – +35 °C
Make sure that the
Do not pull the power
Battery status
The battery is charging.
The battery is 80% charg-
ed.
The battery is fully charg-
ed.
Troubleshooting
Refer to
of the battery charger on
page 18 .
Troubleshooting
Refer to
of the battery charger on
page 18 .
15