Husqvarna Aspire LC34-P4A Manuel D'utilisation page 16

Battery status LED on the product
When the battery is installed in the product, the LEDs on
the product show the battery status.
(Fig. 36)
LED
LED 1, 2 and 3 are
lit.
LED 1 and 2 are lit.
LED 1 is lit.
LED 1 flashes.
To start the product
1. Open the battery lid.
2. Put a charged battery in the battery holder.
3. Turn the safety key to 1. (Fig. 37)
4. Stay behind the product.
5. Loosen the start inhibitor. (Fig. 26)
6. Push the motor brake handle in the direction of the
handlebar. (Fig. 38)
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
Motor stalling
During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. Refer to
on page 17 .
WARNING:
cutting cover, release the motor brake
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
16
Battery status
Fully charged.
Sufficiently charged
The battery power is low.
The battery is empty. The bat-
tery status indicator flashes.
Charge the battery. Refer to
charge the battery on page 15 .
To clean the product
Before a check of the
Before you do
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 39)
2. Open the battery lid and turn the safety key to 0.
To
(Fig. 40)
3. To remove the battery, push the release button and
pull out the battery. (Fig. 41)
4. Charge the battery if it is weak. For more
information, refer to
15 .
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 17 .
Maintenance
For more detailed information, refer to
www.husqvarna.com.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety on page 8 .
handle, turn the safety key to 0, remove
the battery and wait for a minimum of
5 seconds. There is a risk of injury if
the obstacle is removed and the product
accidentally starts.
WARNING:
Turn the safety key to 0
before you let the product out of view.
To charge the battery on page
1848 - 004 - 17.08.2023
To clean the