Husqvarna Aspire LC34-P4A Manuel D'utilisation page 17

Do a general inspection.
Clean the product.
Do a check of the start inhibitor. *
Make sure that the safety devices on the product operate correctly and are not
damaged. *
Examine the cutting equipment.
Examine the cutting cover. *
Do a check of the motor brake handle. *
Examine the battery for damage.
Do a check of the battery charge.
Make sure that the release button on the battery operates correctly and that the
battery locks into the product.
Examine the battery charger for damage and make sure that it operates correct-
ly.
Examine the connections between the battery and the product. Also examine the
connection between the battery and the battery charger.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can get damaged.
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use water to clean the product. Water can
enter the battery or the motor and cause short circuit
or damage to the product.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
To clean the battery and the battery
charger
WARNING:
the battery charger with water.
WARNING:
substances to clean the battery.
1848 - 004 - 17.08.2023
Do not clean the battery or
Do not use any chemical
Each use
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To examine the cutting equipment
WARNING:
turn the safety key to 0, remove the battery
and wait a minimum 5 seconds.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage
or cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes
the product to stop, replace the damaged blade. Let the
Each
Monthly
season
X
X
X
X
X
X
X
X
X
X
X
To prevent accidental start,
Use protective gloves
X
17