Publicité
gegen unbeabsichtigtes Einschalten
(z. B. auf Reisen) geschützt.
Änderungen vorbehalten.
Dieses Gerät entspricht der EU-
Richtlinie EMV 89/336/EWG.
Das Gerät darf am Ende seiner
Lebensdauer nicht mit dem Hausmüll
entsorgt werden. Die Entsorgung
kann über den Braun Kundendienst oder
lokal verfügbare Rückgabe- und Sammel-
stellen erfolgen.
English
Batteries
Two 1.5 volt batteries.
For best performance, use alkaline
manganese batteries (type LR 6, AM 3, MN
1500 or size AA alkaline, e. g. Duracell
These batteries provide a shaving capacity
of approx. 60 minutes.
To open the battery cover (6), turn it 90° as
shown in (c). Insert batteries with the poles
in the direction marked. Before closing the
battery compartment, make sure the cover
is dry and clean.
Note: Never leave batteries in the shaver
for long periods of time when the shaver is
not in use (danger of leakage). Take empty
batteries out of the shaver immediately.
To protect the environment, dispose
of empty batteries at your retail store
or at appropriate collection sites
according to national or local regulations.
This appliance is suitable for use
in a bath or shower. When using it
in a shower, we recommend that
you apply shaving foam or gel.
Shaving
Turn the twisting protective cap (4) (a) until
it clicks in place as shown (b). To switch the
shaver on, push the on/off switch (3) up.
Long hair trimmer
(P70 and P60 models only)
Use the extendable long hair trimmer (5) for
exact trimming of side burns and mous-
taches. To operate, slide the long hair
trimmer to the right (e) and turn on the
appliance. After use, slide it back until it
engages.
Cleaning and maintenance
For optimum shaving performance, clean
the shaver after each use:
Cleaning under running water
Turn on the shaver and hold the shaver
head under warm running water (f). You
may also use liquid soap. Rinse off all foam
and let the shaver run for a few more
seconds. Then turn it off and remove the
shaver foil (1) as shown (g) and let it dry.
If you often clean your shaver under
running water, put a drop of light machine
oil onto the shaver foil.
Cleaning with the brush
Remove the shaver foil (1) and tap it gently
against a flat surface. Then thoroughly
4
®
).
Publicité
