Wilfa PROBAKER TIMER Instructions page 23

Problem Possible Cause
Not enough content
in bowl
(The whisk balloons are
designed to automatically
Whisk hits bottom
adjust their height based
of bowl
on content. This means that
with a very small amount of
content the whisks might
touch the bottom of the
bowl)
Power switch next to the
power inlet is in OFF
position (O)
Power cable not
properly in place
Machine will
Head is not properly
not start
closed
Motor is overheated
Speed indicator Speed not set to 0
ring is blinking on when machine starts
power up
Debris or grease in the
mounting point
The flexi-beater
silicone scraper
The flexi-beater is not
loosens
the correct tool for
heavier doughs like
yeasted dough and
shortcrust pastry
KITCHEN MACHINE · KM2GY-T70
Action
Add more content
Set power switch to the ON
position (I)
Ensure the plug is fully
connected
Close the head until it properly
locks in place
Probaker cuts power when the
motor temperature becomes
too high. Unplug the device
and let it cool for at least 30
minutes
Set speed knob to 0
Clean silicone ring and the
flexi-beater thoroughly with
soapy water or in dishwasher
Refer to "tool section". If in
doubt use the spiral hook
23
EN