Télécharger Imprimer la page

mundoclima MUCR-H8 Serie Manuel D'installation Et L'utilisauter page 97

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WIRED CONTROLLER
Faceplate function (on some models)
1.When the unit is off Press the Mode(A/B) button long to activate the
Mode
2. Push the Mode(A/B) button to select Unit A or Unit B, the wire controller select in a
sequence that goes from (this step do not need to perform if the wire controller is
connected with one unit only):
3. Press the button + and - to control the lift and drop of the faceplate.
Pressing the + button can stop the faceplate,while it is dropping.
Pressing the - button can stop the faceplate,while it is lifting.
Left-right airflow swing (on some models)
Swing
Press the swing button long to activate the auto Left-right swing function.
And then the louver would swing automatically.Press it again to stop.
When the auto Left-right swing feature of the louver is activated, the
(Not applicable to all the models)
Up-Down airflow direction and swing (on some models)
Swing
Swing function (For the unit without left & right auto swing function models)
Up-Down airflow direction and swing
Swing
1.Press the button every time, the louver swings 6 degrees.
2.Press and hold the button for 2 seconds,it turns into up-down swing mode,
press ti again to stop.
When the Up-Down swing function is activated, the
(Not applicable to all the models)
The operation can refer to the following instructions for the unit with four Up-Down
louvers can be operated individually.
1.Press the Swing button to activate the Up-Down adjusting
louver function.
The
mark will flash.(Not applicable to all the models)
2.Pressing the button "+"
of four louvers.Each time you push the button,the wire
controller select in a sequence that goes from:(the icon
means the four louvers move at the same time.)
-0
-0
-1
3. And then use Swing button to adjust the Up-Down airflow direction of the selected
louver.
faceplate function. The
The F2 mark appears when
the faceplate is adjusted.
A
B
Press the Swing button to start up-down swing function.
Press it again to stop.
When the Up-Down swing function is activated, the
(Not applicable to all the models)
Use Swing button to adjust the Up-down airflow direction.
can select the movement
-2
-3
-4
mark will flash.
mark appears.
mark appears.
Swing
-
97
mark appears.
+

Publicité

loading