Sony TC-WE825S Mode D'emploi page 17

7
Press SYNCHRO.
If your CD player has the Peak Search function:
The SYNCHRO button indicator lights up and the CD
player locates the highest signal level among the tracks
to be recorded as the tape deck adjusts the recording
level. When the recording level adjustment is
completed, CD Synchro-Recording starts.
If your CD player does not have the Peak Search
function:
The CD player changes to play pause and deck B to
recording pause. Press PAUSE P on deck B to start
Synchro-Recording.
To stop CD Synchro-Recording
Press p on deck B or the CD player.
z
You can use an optional remote to operate the CD
player
To start CD play, press P twice; to pause CD play, press
P once; to locate a CD track, press = or +.
z
If the SYNCHRO button indicator goes off after
flashing three times
The tape cannot be recorded on because the record-
protect tab(s) on the cassette has (have) been removed.
z
Length of tape used for recording
Tracks on a CD differ in length. Classical music CDs
and others often have tracks that exceed the recording
time of a single cassette side. In this case, record the
tape manually.
z
When recording from the middle of the tape
A tape that is inserted and has not been played or
recorded on is assumed by the deck to be a new tape,
even if the present location is in the middle of the tape.
The deck will transport the tape for 10 seconds before
starting CD Synchro-Recording to bypass the portion
corresponding with the leader. To begin CD Synchro-
Recording without the ten-seconds delay, play or record
on the tape for a few seconds before starting the CD
Synchro-Recording procedure.
z
If the tape ends during CD Synchro-Recording on the
front side of the tape (· lights up) and DIRECTION
MODE is set to a or RELAY
Recording of the track ends immediately, the tape
direction is reversed, and recording starts again from
the beginning of the track. If the tape ends on the
reverse side of the tape (ª lights up), CD Synchro-
Recording stops and the CD player stops playing.
Advanced Recording Operations
Notes
• To prevent interruption of the recording process, do not
press any operation buttons on the CD player during CD
Synchro-Recording.
• Certain operation buttons on the tape deck are disabled
during CD Synchro-Recording.
EN
17