Publicité
Les langues disponibles
Les langues disponibles
EN
Charging Time:
LCD will show "100%" as fully charged. Charging time will differ based on the discharge level and the power source used. If charging begins from 5% to full
charge, it approximately takes 7 hours for AC charging.
Flashlight
Press Flashlight button to start flashlight. Press once to switch lighting modes: Steady On –Strobe – SOS – Off.
USB Power
Connect the USB device to the Device with either the original cable or the included multi-tip cable (better use original cable of Apple® for Apple® products).
Press once Digital Display On/Off button to start USB power. When disconnected, the Device will automatically shut off. The number of times you can recharge
a USB device will vary between devices.
Supply to 12v devices
The Device can run/charge 12VDC appliances that draw 10 amps or less. Two Options as follows:
1) Connect the Device to 12V devices with optional accessory (This item does not include the accessory). Press once Digital Display On/Off button to start 12V
power. When disconnected, the Device will automatically shut off.
2) Connect the Device to 12V devices by the included accessory. Press Engine Start
On/Off button once to activate the 12V power supply (Icon 3 in page 3 will be lit). When you unplug the 12V devices from Device, do remember to press Engine
Start On/Off button again to stop the output. If battery voltage of Device is too low, 12V devices will stop running/charging.
4
WWW.NIKOLAOUTOOLS.GR
Publicité
