Publicité
Les langues disponibles
Les langues disponibles
Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. If these stains
are difficult to remove, use only specialised
products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft cloth.
Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
To clean more thoroughly, you can remove the
oven door.
1. Open the oven door fully ( see diagram )
2. Lift up and turn the small levers located on the
two hinges ( see diagram )
3. Grip the door on the two
external sides and close it
approximately half way. Then
pull the door towards you
lifting it out of its seat ( see
diagram ).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). We
All manuals and user guides at all-guides.com
recommend not using the oven until the seals have
been replaced.
Replacing the light bulb
3. Replace the glass cover ( see diagram ).
Assembling the sliding rack kit
To assemble the sliding racks:
4. Finally, fit the frames on the spacers A.
! Do not place the sliding racks in position 5.
1. Remove the two
frames, lifting them
away from the spacers
A ( see figure ).
A
2. Choose which shelf
Left
Right guide
to use with the sliding
guide rail
rail
rack. Paying attention
to the direction in which
the sliding rack is to be
B
extracted, position joint
C
B and then joint C on
the frame.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls ( see diagram ).
The holes for the left
D
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
GB
To replace the
oven light bulb:
1. Remove the
glass cover of the
lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
Wattage 25 W,
cap E 14.
21
Publicité
