Troubleshooting - Springlane Hanno Mode D'emploi

"Cleaning". The programme starts automatically and runs as follows: It runs for
one minute – 10 times with the pulse function and subsequently in continuous
operation, gradually increasing in speed, starting at minimum and ending at
maximum speed. Remove the container from the motor block and subsequent-
ly rinse. Repeat the process if needed.
8. Allow the container and individual parts to dry properly before reassembling.
The power cable, device plug, and motor should not come into contact
with water. Be careful of the sharp blades when cleaning the knife insert
and mixer container.

TROUBLESHOOTING

Please go through the following steps if the device does not operate as desired:
1. Inspect whether the instructions in the operating manual were followed preci-
sely and correctly.
2. Inspect whether the table below offers potential solutions.
3. Inspect whether your fuses are still intact or not.
Problem
The operating
buttons do not
light up, the
device does not
work.
The operating
buttons light up,
the device does
not work.
34
• Place the mixer container onto the motor head and
plug the power cable into the socket.
• Press the container down again to reactivate the
security switch.
• Place the mixer container onto the motor head and
plug the power cable into the socket.
• Turn back the dial controller to position "0". Conti-
nue with the desired speed/functions.
Solution