Publicité
Les langues disponibles
Les langues disponibles
99625941_ML_A.qxd
18/11/02
I
nstalling your hood
1. Pre-installation recommendations:
The distance between the cooking plane and the bottom of the hood must not be less
than 70 cm. If the instructions of the gas cooker installed under the hood specify a dis-
tance greater than 70 cm, then this distance must be respected.
Proceed as follows:
- Mark a vertical line on the wall, to ensure that your hood (and its chimney) are per-
fectly aligned with your cooker.
- Make a mark, on the vertical line, at least 70 cm above your cooking plane.
The vertical line and the mark at 70 cm will help you set up the installation as shown in
the attached installation diagram.
2. Installing the body of the hood:
- Place the installation diagram supplied against the wall, and align the vertical line
on the wall with the " hood centreline " shown on the diagram.
- Drill four holes, dia. 8 mm, as shown on the diagram.
- Mount the two supports on the wall, using the four screws and plugs supplied with
the duct (fig. 1).
Remark: In the case of a hollow wall, use the appropriate screws and plugs.
- Mount the hood by locating its rectangular holes on the supports.
The width of the holes is sufficient to allow some margin for left/right adjustment.
IMPORTANT :
- Adjust the height and levelling using the support adjustment screws " A " (fig.1),
and then mount the hood firmly against the wall by tightening the screws " B " (fig. 1).
13:47
Page 5
All manuals and user guides at all-guides.com
rectangular holes
B (Phillips head,
length: 25 mm)
A (hex. head,
length: 8 mm)
GB
fig. 1
5
Publicité
