Brandt AD289XT1 Guide D'utilisation page 11

99625941_ML_A.qxd 18/11/02
C
leaning your hood
The hood should be switched off before the metal filters are removed.
After cleaning, the metal filters should be installed, as described in the
instructions.
1. ROUTINE MAINTENANCE
Never use metal cleaning pads, abrasive products or excessively hard brushes.
Do not clean the stainless steel using ammonia-based products.
To clean the outer casing and the lighting window, use only household cleaning products,
diluted in water, rinse with clean water and wipe with a soft cloth.
2. MONTHLY MAINTENANCE: metal filter
The filter retains greasy vapours and dust, and is very important for the efficient opera-
tion of your hood.
It can progressively become inflammable, as it becomes saturated with greasy residue.
Clean the metal filter using commercial household cleaner, rinse thoroughly and dry.
In the dishwasher, this cleaning should be done using the filter only, in the vertical posi-
tion. Do not clean the filter at the same time as the dirty dishes because of the risk of
leaving stains.
Before using the metal filter for the first time, remove the protective film.
- To remove the metal filter:
1. Raise the filter handle.
After cleaning, install the filter by carrying out the above operations, in the reverse sequence.
The integral handle can be positioned to the left or to the right, as convenient.
3. ANNUAL MAINTENANCE: active carbon filter
ONLY for hoods operating in recycling mode (not connected to an evacuation to
outdoors). This filter retains smells and should be changed at least annually, as a func-
tion of utilisation and to avoid any risk of fire. Filters may be obtained from your Brandt
dealer (see part number shown on identification plate, inside the hood). Note the instal-
lation date of a new filter.
Before carrying out any work on the hood, check that it is
switched off.
13:48 Page 11
All manuals and user guides at all-guides.com
Handle
2. Rotate the filter downwards.
GB
11