Publicité
Les langues disponibles
Les langues disponibles
Figure 17
1. Washout port
6.
Turn the water on.
7.
Start the motor and run it until the clippings no
longer come out from under the machine.
8.
Shut off the motor.
9.
Shut off the water and disconnect the garden
hose from the motor.
10.
Start the motor and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11.
Shut off the motor, remove the electric-start
button, and allow the it to cool before storing the
machine in an enclosed area.
Cleaning under the Machine in the
Vertical-Stow Position
1.
Set the machine in the vertical-stow position;
refer to
Storing the Machine in the Vertical-Stow
Position (page
19).
2.
Wash out the clippings from under the machine.
Folding the Handle
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1.
Remove the electric-start button
g251300
2.
3.
4.
5.
(Figure
18).
18
Figure 18
Hold the handle while disengaging the handle
locks to avoid pinching your hands.
Disengage the handle locks until you can move
the upper handle freely.
Fold the handle forward either to the vertical
position or the fully forward position as shown
in
Figure
19.
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
Figure 19
To unfold the handle, refer to
Handle (page
9).
g251288
g251299
2 Unfolding the
Publicité
